[AT] Ok now how about George Willer?(roll call)

[charliehill]

I understand Bob,  same here.  To top all of that off I went out to my 
mowing tractor yesterday and it has a flat rear tire.  The fun never stops.


----- Original Message ----- 
From: "Bob McNitt" <nysports at frontiernet.net>
To: "Antique tractor email discussion group" <at at lists.antique-tractor.com>
Sent: Thursday, August 06, 2009 8:42 PM
Subject: Re: [AT] Ok now how about George Willer?(roll call)


> Charlie -
>
> Due to the terribly wet late spring and (so far) summer we've had, I've 
> been
> up to my eyeballs keeping up with mowing and bush-hogging. Like a fool, 
> I'm
> also tearing out our old patio to be replaced this year. AND am running a
> new dedicated buried electrical line to our four out buildings.
>
> So my checking on the list usually is when I have a few minutes to spare
> when I'm not either working, eating or sleeping.
>
> Bob in CNY
> ----- Original Message ----- 
> From: "charliehill" <charliehill at embarqmail.com>
> To: "Antique tractor email discussion group" 
> <at at lists.antique-tractor.com>
> Sent: Thursday, August 06, 2009 4:16 PM
> Subject: Re: [AT] Ok now how about George Willer?(roll call)
>
>
>> Hi Ralph,  I'm glad you checked in.  You were another that hasn't said
>> anything lately.   I'm sure there are a lot of others I should ask about
>> but
>> I just take them as they pop into my mind.
>>
>> How are the crops in Sask. this year?
>>
>> Charlie
>> ----- Original Message ----- 
>> From: "Ralph Goff" <alfg at sasktel.net>
>> To: "Antique tractor email discussion group"
>> <at at lists.antique-tractor.com>
>> Sent: Thursday, August 06, 2009 3:41 PM
>> Subject: Re: [AT] Ok now how about George Willer?(roll call)
>>
>>
>>>> The traffic on our  list has slowed down to the point that sometimes I
>>>> think
>>>> we need to have a roll call.
>>>>
>>>> Charlie
>>>
>>> Charlie, its slow alright but I'm still here reading whatever does show
>>> up
>>> on the list. I've been working on newer stuff lately, removing the pto
>>> drive
>>> and hydro pump from my CIH 1660 combine for repair. Lots of heavy 
>>> lifting
>>> and expensive parts but we are slowly getting it back together.
>>> http://www.redpowermagazine.com/forums/index.php?act=attach&type=post&id=73057
>>> Did put in a little old tractor time recently running the Cockshutt 40 
>>> on
>>> the New Holland sickle bar mower cutting some hay. The hay field (old
>>> yard)
>>> was so rough that it loosened up the spline on one of the rear axles of
>>> the
>>> 40 and I had to tighten it up yesterday. It had started to leak oil and
>>> was
>>> making a clunking noise that caught my attention. Don't want to run it
>>> that
>>> way for long or it will ruin the splines.
>>> (Wish I could repair my neck and back joints as easily).
>>>
>>> Ralph in Sask.
>>> ----- Original Message ----- 
>>> From: "charliehill" <charliehill at embarqmail.com>
>>> To: "Antique tractor email discussion group"
>>> <at at lists.antique-tractor.com>
>>> Sent: Thursday, August 06, 2009 12:55 PM
>>> Subject: [AT] Ok now how about George Willer?
>>>
>>>
>>>
>>>
>>> --------------------------------------------------------------------------------
>>>
>>>
>>>
>>> No virus found in this incoming message.
>>> Checked by AVG - www.avg.com
>>> Version: 8.5.392 / Virus Database: 270.13.45/2285 - Release Date:
>>> 08/06/09
>>> 05:57:00
>>>
>>> _______________________________________________
>>> AT mailing list
>>> http://www.antique-tractor.com/mailman/listinfo/at
>>
>> _______________________________________________
>> AT mailing list
>> http://www.antique-tractor.com/mailman/listinfo/at
>
>
> --------------------------------------------------------------------------------
>
>
>
> Internal Virus Database is out of date.
> Checked by AVG.
> Version: 8.5.238 / Virus Database: 270.13.8/2226 - Release Date: 07/08/09
> 21:51:00
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at