[Farmall] Seeing daylight again
Andy Wander
awander at verrex.com
Sat Jun 7 10:00:39 PDT 2008
John:
I haven't done it, but I bet if you took a pipe cutter and dulled the cutting wheel, it would work great!
______________________________________
Andy Wander
Date: Sat, 7 Jun 2008 07:01:31 -0400
From: "John Hall" <jthall at worldnet.att.net>
Subject: [Farmall] Seeing daylight again
To: "Farmall/IHC mailing list" <farmall at lists.antique-tractor.com>
Message-ID: <004101c8c88d$d89f1f70$16d14c0c at D48VHZ61>
Content-Type: text/plain; format=flowed; charset="iso-8859-1";
reply-type=original
I drug my Regular out from the back of the shed where it resides for the
first time in quite a while (3 years or more?). During this long storage it
managed to get a stuck valve so we had to pull the valve cover and do a
whole lot of persuading to get it to free up. No sign of rust so not
certain why it seized. anyway, got that straightened out and decided it was
time to get the handle on the crank to spin. A whole lot of heating later I
let it cool and started putting penetrating oil in it. Finally I could see
it wiggle. A little more and it was loose. Then the bad part--it worked so
loose it came completely off the end. So now I am planning to build a
crimping die so I can hopefully make it stay on the crank. Anyone here ever
successfully do this?
John Hall
------------------------------
_______________________________________________
Farmall mailing list
Farmall at lists.antique-tractor.com
http://www.antique-tractor.com/mailman/listinfo/farmall
End of Farmall Digest, Vol 50, Issue 3
**************************************
This communication including any attachments, are intended
for the exclusive use of the addressee(s) and contains
confidential or copyrighted materials. Duplication,
distribution or reproduction is strictly prohibited by law
without written permission of Verrex
More information about the AT
mailing list