[AT] Help with Radiator Leak, Please?

Mattias Kessén davidbrown950 at gmail.com
Thu Jan 24 22:17:07 PST 2008


Richard, once a lifetime is acceptable :-)

Mattias


2008/1/25, Richard Fink Sr <nancydick at pennswoods.net>:
>
> OK Mattias i could be wrong but it has never happened before 8-)
> R Fink
>
>
> At 10:16 PM 1/24/2008 +0100, you wrote:
>
> >I've always heard that you should use white pepper :-o
> >
> >Mattias
> >
> >
> >2008/1/25, Richard Fink Sr <nancydick at pennswoods.net>:
> > >
> > > Wayne if the pellet is still in the hole. fill radiator with water
> > > add about 4 table spoons of BLACK pepper keep it full and run till
> > > warm up it will seal the leak.
> > > That is about as cheap as you can get.
> > > R Fink
> > > PA
> > >
> > >
> > >
> > > At 10:02 AM 1/24/2008 -0800, you wrote:
> > >
> > >
> > > >I am looking for a good and cheap fix on an old radiator. I don't
> > > >think I can use "good" and "cheap" in the same sentence, but here is
> > > >my question.
> > > >
> > > >I purchased an old welder, made by General Electric.  The
> > > >manufacturers label said the engine was a four-cylinder Hercules, but
> > > >upon closer inspection the engine is actually a four-cylinder
> > > >Continental.  Too bad too, as I have been looking for some time for a
> > > >Hercules 1XB3 engine or similar replacement for another project.
> > > >
> > > >The welder was dragged out of the bush behind the owner's house from
> > > >under a mess of blackberry bushes.
> > > >
> > > >Oh yes, to my question...
> > > >
> > > >At some point in history, someone has shot a pellet gun at the
> > > >radiator.  The pellet is still visible in the cooling tube.  The
> > > >radiator leaks at this hole.
> > > >
> > > >I read somewhere that to repair a radiator, a person purchased a
> > > >special clip that fit over the tube and was soldered into place.  I
> > > >may have found this information in an old equipment manual.
> > > >
> > > >The most commonly used method of repair that I have seen is to break
> > > >away the cooling fins between the tubes around the hole and just
> > > >solder up the hole.  While this might be very functional, I have not
> > > >been impressed with the looks of the completed work.
> > > >
> > > >Now, here is the question -- Does anyone here have any suggestions
> > > >that I might try to make a near "Invisible" repair to the radiator?
> > > >
> > > >This may be off topic, for which I apologize.
> > > >
> > > >
> > > >Wayne
> > > >Vancouver Island, BC
> > > >
> > > >
> > > >
> > > >
> > > >==
> > > >
> > > >ICQ Number 1625774
> > > >
> > > >1930(?) Case Model L(?), gas - with Hough loader - Rescued - not
> running
> > > >1933 IHC T-20, Gas Crawler with blade - Running
> > > >1940's (?) Hyster Karry Krane (Cranemobile), 5 ton lift - Model CM;
> > > >Serial 115, with Hercules 1XB3 4 cyl gas - Rescued - not running -
> > > >Hercules IXB3 engine has major parts missing..
> > > >1947 Massey-Harris Pony, gas - Model 11 - Serial PGS-1256 - running
> > > >1948 McCormick Farmall H, gas - Serial FBH-272855 with Loader -
> > > >running; needs clutch
> > > >1947-55(?) Towmotor Forklift, 4,000 lb lift - gas - no Serial -
> > > >partial restore - running
> > > >1950(?) IHC Stationary Engine(same as Farmall H) with Trans and flat
> > > >belt pulley - running
> > > >1951 IHC TD-9, Diesel Crawler/bulldozer - Serial TDCB-42774 - engine
> > > >being re-worked.
> > > >1952 IHC TD-9, Diesel Crawler/bulldozer - Serial TDCB-56552 - needs
> > > >final gears  not running
> > > >1952(?) Earthmaster tractor, gas - no serial, not running
> > > >1953 Thew/Lorain 15 ton Truck Crane, serial 24876 - 40 ft boom, two 6
> > > >cylinder gas - partial restore - running
> > > >1967 Ford Thunderbird 2 Door - Older Restore
> > > >1975 Kubota B6000, Diesel 4x4 - with loader and backhoe - Rebuilt
> > > >1999 - running
> > > >1980 Case 580C, Diesel Loader/Backhoe - Serial 9011002 - running
> > > >1984 Mustang convertible - running
> > > >1998 John Deere 870 4WD, Diesel - with loader - running
> > > >...and some more engines, compressors and welders
> > > >
> > > >Accessories:
> > > >1947 Champion Sparkplug tester and cleaner
> > > >1950  Sun Dwell and Tach meter
> > > >...and more
> > > >
> > > >_______________________________________________
> > > >AT mailing list
> > > >http://www.antique-tractor.com/mailman/listinfo/at
> > > >
> > > >
> > > >--
> > > >No virus found in this incoming message.
> > > >Checked by AVG Free Edition.
> > > >Version: 7.5.516 / Virus Database: 269.19.10/1240 - Release Date:
> > > >1/23/2008 5:47 PM
> > > >
> > > >
> > > >
> > > >
> > > >--
> > > >No virus found in this incoming message.
> > > >Checked by AVG Free Edition.
> > > >Version: 7.5.516 / Virus Database: 269.19.10/1240 - Release Date:
> > > >1/23/2008 5:47 PM
> > >
> > >
> > > --
> > > No virus found in this outgoing message.
> > > Checked by AVG Free Edition.
> > > Version: 7.5.516 / Virus Database: 269.19.10/1240 - Release Date:
> > > 1/23/2008 5:47 PM
> > >
> > >
> > > _______________________________________________
> > > AT mailing list
> > > http://www.antique-tractor.com/mailman/listinfo/at
> > >
> >
> >_______________________________________________
> >AT mailing list
> >http://www.antique-tractor.com/mailman/listinfo/at
> >
> >
> >--
> >No virus found in this incoming message.
> >Checked by AVG Free Edition.
> >Version: 7.5.516 / Virus Database: 269.19.10/1241 - Release Date:
> >1/24/2008 9:58 AM
> >
> >
> >
> >
> >--
> >No virus found in this incoming message.
> >Checked by AVG Free Edition.
> >Version: 7.5.516 / Virus Database: 269.19.10/1241 - Release Date:
> >1/24/2008 9:58 AM
>
>
> --
> No virus found in this outgoing message.
> Checked by AVG Free Edition.
> Version: 7.5.516 / Virus Database: 269.19.10/1241 - Release Date:
> 1/24/2008 9:58 AM
>
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>




More information about the AT mailing list