[AT] Hand Crank Pin

[Gene Dotson]

    Keith;
    I have used drill rod pretty successfully. Usually stake the center of 
the pin with a sharp chisel in about 4 places to make it fit tighter..

                        Gene



----- Original Message ----- 
From: "Keith Kinney" <kkinney at herculesengines.com>
To: "Antique tractor email discussion group" <at at lists.antique-tractor.com>
Sent: Thursday, January 10, 2008 9:19 PM
Subject: [AT] Hand Crank Pin


> >
> I was checking out the Clark Airborne crawler the other day.  I put
> the hand crank in it's slot and gave it a tug, nothing.  So I put a
> foot on it and I'm pretty sure it moved about 1/8th of a turn :-)  So
> a few days later I tried again.  But, this time I went a little too
> far.  I stood on the crank.  Ok, I kind of jumped on the crank.  Well
> as you can guess something gave.  Luckily it was only the pin in the
> end of the crank handle.  Now for my question, what do I use to
> replace that pin and how is it locked into the crank?
> Thanks.
> Keith
>
>
>
>
> Keith Kinney
> kkinney at herculesengines.com
> WWW.HerculesEngines.com
>
>
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>