[AT] Don't scratch the paint!
Cecil Bearden
crbearden at copper.net
Sun Aug 17 05:59:57 PDT 2008
It was a pit silo. One of the wagons had a moveable angled front end
gate that had rubber belting on the sides. It had a chain bridle
attached that would pull the load of grain out of the back afer you
opened the rear endgate and attached a tractor. This may be the same
type of arrangement. I grew up with very tight German immigrant farmers
who had some real ingenuity.
Cecil in OKla
John Hall wrote:
> That must have been a sight to see--a heck of a lot more weight there than
> what we were dealing with. Was this a pit tpe silo you were putting it in?
>
> This talk of unloading somewhat reminds me of the old timers uloading a
> grain truck with a cable pulled device similar to a horse plow. You removed
> the tailgate and climbed into the truck and "plowed" the load out. From what
> I gather it was short lived method and replaced by cable or hydraulic lift
> front end lifts.
>
> John
>
> ----- Original Message -----
> From: "Cecil Bearden" <crbearden at copper.net>
> To: "Antique tractor email discussion group" <at at lists.antique-tractor.com>
> Sent: Saturday, August 16, 2008 11:41 PM
> Subject: Re: [AT] Don't scratch the paint!
>
>
>> we would unload silage wagons in much the same way. We would lay Hog
>> wire with one end fastened to a pipe which rode on top of the sidepaords
>> at the front. The wire was then covered with chicken wire to hold the
>> silage on top of the hog wire. The wire was long enough that it would
>> go from the top of the sideboards down to the floor and then to the rear
>> of the trailer where it was turned up and held with a rope between the
>> sideboards to hold the wire up to make an endgate. When we got to the
>> silo with a loaded wagon, untie the rope, hook a long cable to the
>> bridle chain attached to the post at the front and pull off an entire 16
>> ft wagon load of silage in about 30 seconds. A kid on each end would
>> pull the pipe and wire back into the wagon and tie up the rear end and
>> "fly" back to the field to get another trailer. We had 3 trailers
>> running between the silage cutter and the silo. One time we had 5 miles
>> between the field and the silo. We got 2 more trailers and a truck and
>> used a pickup to pull the trailers. When all the kids went away to
>> college and got jobs, we quit putting up silage....
>>
>> Cecil in OKla
>>
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>
More information about the AT
mailing list