[AT] Bending a hook on a spring

[Len Rugen]

I've been thinking.....    One of the scrap springs had a screw-in end.  
That worked on the long application, but 2 of those ends would use all 
the spring I'll need. 

I'm thinking about putting a metal strap THRU the last loop or two, then 
bending it's ears back over the end of the spring.  Have a square hole 
inside and use a carriage bolt.  The bolt would keep the strap from 
sliding out to the side and the ears over the bolt again would keep it 
from bending and sucking out the end.... 

Or.... Does anyone have a WD-45 seat hardware they don't need?  I would 
need everything from the frame to the pan.  The Joy Ride is almost as 
uncomfortable as an original seat .  The Joy Ride cushion was long gone 
and the original pan was put back.