[Farmall] cub governor

[DBigdog]

Follow the governor rod from the throttle lever down under the hood and 
along the side of the engine.  You will find a couple of pivot points that 
can freeze from corrosion.  A liberal application of penetrating oil and 
some judicious application of a little pressure should free it up.  Also 
check the rockshaft that goes across the front of the engine block and make 
sure that linkage is free as well.  If it is not in the linkage, you will 
have to disassemble and clean the governor.  If you need to do that, bring 
number 1 cly. up on TDC before disassembly.  The governor is timed to the 
engine and the distributor is timed to the governor so it is easy to get 
them out of time.
----- Original Message ----- 
From: Ed Phipps
To: farmall at lists.antique-tractor.com
Sent: Tuesday, September 11, 2007 8:44 PM
Subject: [Farmall] cub governor


   The governor on my cub is stuck, will not and it has the tractor
at constant half throttle, does anyone know how to fix it?
  Thanks
   snakedoc
_______________________________________________
Farmall mailing list
http://www.antique-tractor.com/mailman/listinfo/farmall