[AT] OT - paint stripping

[JTakemoto at wildblue.net]

On fenders, hoods and most flat metal I use a propane torch and a scraper
or metal brush. Hit it quick with torch until it curls up then scape it
off sand till smooth real quick this way. Oh don't do the gas tank. BOOM.
J.

>     Mike;
>
>     I use Easy-Spray paint remover. It does a good job removing the paint.
> You will want to use it outside or in a well ventilated shop. It can be
> sprayed or brushed on, but brushing works best. Wear gloves and be
> careful.
>     I usually buy it at local Meijer's store. Lowe's may carry it too.
> Comes
> in a blue, white and yellow can.
>
>                 Gene
>
>
>
> ----- Original Message -----
> From: "Mike" <msm10301 at juno.com>
> To: <at at lists.antique-tractor.com>
> Sent: Friday, November 16, 2007 11:00 PM
> Subject: [AT] OT - paint stripping
>
>
>> Hi all,
>> This is OT but the input could be used for old tractor parts as well.
>> I'm
>> painting a room in our house, and would like to strip all the paint off
>> the registers (many coats) and repaint them. Is there a solution I can
>> mix
>> up in a 5 gallon pail that will eat off the paint. Any input
>> appreciated.
>>
>> Mike
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>