[AT] Truck hitch questions

[Tim Bivens]

Clean it out with a wire brush on a die grinder.
Tim

--- jahaze at aol.com wrote:

> 
> I have a 2" receiver hitch on my truck.  The hitch
> is 10 years old and hasn't been used much in the
> past few years since I now have a gooseneck
> trailer.  My problem is despite my best efforts to
> keep it cleaned out, over the years it has rusted on
> the inside to the point where I can no longer insert
> at hitch (without using a sledge hammer). There is
> isn't any large scale rust, but the inside diameter
> has "shrunk" enough that I'm trying to decide if I
> should just replace the whole thing, or grind off my
> insert to fit the smaller diameter.  Has anyone else
> run it this?  What did you do?  Maybe I can have
> someone sandblast the inside for me?
> 
> Enjoy, Joe
>
________________________________________________________________________
> AOL now offers free email to everyone.  Find out
> more about what's free from AOL at AOL.com.
> 
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>