[Farmall] broken easy out

[Alan Riley]

Tony, I thing you may just compound the problem by expanding the bolt
inside the hole by doing it this way.  A die grinder or Dremel with an
appropriately sized diamond burr could be used to provide a flat surface
on the bolt end without expanding the bolt.

Good luck,
Alan

   
----- Original Message ----- 
From: "Anthony Flint" <tony at flintservices.com>
To: <farmall at lists.antique-tractor.com>
Sent: Saturday, December 29, 2007 12:30 PM
Subject: Re: [Farmall] broken easy out


> 
> I'm considering using a flat-nosed round punch that's ground down to just
> under the thread diameter, heating the bolt to some degree and slowly
> flatten the point at much as possible to allow for drilling.
> 
> Tony
>