[AJD] Plow Measur

[Duane Ledford]

Say you have a two bottom plow. Mark a line from the rearward bottom's point 
straight forward  past the forward bottom, making essentially a parallel 
line between the two bottoms. The distance from the point of the forward 
plow point to the line coming from the rearward plow point is your 
measurment. 12, 14, 16,etc. On a lot of plows, you can measure the distance 
between beams, but not all, as some have offset shanks. Clear as mud now?
----- Original Message ----- 
From: "Frank" <gremaux at midrivers.com>
To: "Antique John Deere mailing list" 
<antique-johndeere at lists.antique-tractor.com>
Sent: Monday, September 11, 2006 6:28 PM
Subject: Re: [AJD] Plow Measur


> still do not understand
>
> Frank
> gremaux at midrivers.com
> Central Montana
> http://www.angelfire.com/mt/deeregp/index.html
> ----- Original Message ----- 
> From: "Bruce Mahr" <martian at winco.net>
> To: "Antique John Deere mailing list" 
> <antique-johndeere at lists.antique-tractor.com>
> Sent: Monday, September 11, 2006 12:09 PM
> Subject: Re: [AJD] Plow Measur
>
>
>> >From the tip of the share straight out at a 90 degree angle from the 
>> >tip,
>> not the length of the share or moldboard.
>>
>> Bruce Mahr
>>
>> ----- Original Message ----- 
>> From: "Gordon Hart" <grnacres at pgtc.net>
>> To: "Antique John Deere mailing list" 
>> <antique-johndeere at lists.antique-tractor.com>
>> Sent: Monday, September 11, 2006 12:36 PM
>> Subject: [AJD] Plow Measur
>>
>>
>> How are moldboard plows measured?
>> Gordon
>> _______________________________________________
>> Antique-johndeere mailing list
>> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
>>
>>
>> _______________________________________________
>> Antique-johndeere mailing list
>> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
>>
>
>
> _______________________________________________
> Antique-johndeere mailing list
> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere