[Steam-engine] Oil Grooves

Ken Hough k4sb at niia.net
Fri Sep 1 16:32:27 PDT 2006


Did you "tin" the bearing halves with acid core solder first? The babbit 
will grip better. Since the top half bears the weight a simple groove 
parallel to the shaft and 80% its width will work. Make sure this grove is 
centered.
Ken


I am in the middle of pouring the main bearings on the
Huber and I have a question about the oil grooves in
the lower half.  The oil feed in only on the top half
(cap) so I will cut in X grooves on the cap.  What
kind of oil groove, if any, should be on the bottom
half of the bearing?

Andy Glines
Evansville, IN

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 
_______________________________________________
Steam-engine mailing list
http://www.stationary-engine.com/mailman/listinfo/steam-engine
Ken Hough Photographic Repair Service
Specializing in the Complete restoration of
           Deardorff View Cameras 
                            Est 1982
     www.deardorffcameras.0catch.com
                      219 462 0281




More information about the AT mailing list