[Farmall] Farmall H rear tire mounting process.

[Robert L. Holtzer]

Some clarification needed.  Are you refering to removing the rim and 
tire combo?  Assuming you are talking about remounting the rim/tire, 
the rim will center assuming it was centered OK originally.  The 
outside clamps (probably not the right word!) should be installed so 
the nut seating surface is perpendicular to the bolt.  These clamps 
are used for a variety of wheel width settings so they can be 
installed tilted!   I try to mount the rim back in the position 
originally mounted to minimize paint damage.

Bob Holtzer

At 08:32 AM 10/2/2006, you wrote:
>Tractor folks,
>   I had to take the rear tire off of my H to get a new tube put in. I
>removed the outside nuts and took the tire off. Now I need to put back
>on. Is there any special techiniques that are required to mount the tire
>back on ? I need to get equal spacing round the wheel. Does that just
>happen as the nuts are tighted or do I need to somehow space the tire
>before the tightening process ?  Thanks for any suggestions.
>
>   Regards
>   Danny
>
>_______________________________________________
>Farmall mailing list
>http://www.antique-tractor.com/mailman/listinfo/farmall