[Farmall] another clutch question

[Bobby Guilbeau]

On the AV I have a Graphitar Type Release Bearing instead of the standard
throughout bearing, after replacing the clutch which was an Auburn clutch
with a Rockford clutch I realized the face of the Graphitar Bearings is not
as large as the standard roller bearing so the contact point of the
Graphitar Bearing with the fingers/levers of the new Auburn clutch has very
little surface that it make contact with will this cause a problem for me
later?  Or should I attempt to find the parts to go to a roller bearing
release?

 

Bobby Guilbeau, Ranger

Evangeline Area Council - BSA

1771 Mountain Bayou Road

St. Landry, LA  71367