[Farmall] Farmall H rear tire mounting process.

[Robert L. Holtzer]

Yes, the sling concept is a good one.  I use 3/16 to 1/4 nylon rope 
wrapped several loops around the tire and rim in the same fashion 
Kevin does with a strap.  Also use an engine hoist which makes life 
much easier!

Bob Holtzer

At 07:54 AM 10/3/2006, you wrote:
>Bob
>  Your assumption is correct.  I'm talking about the rim and the 
> tire. The sling concept suggested by Kevin sounds like a good idea. 
> I don't have any fluid so that makes it a little easier. The Case 
> shop was not impressed with the condition of my tires. The said 
> something about not making that tread since the 60's. Guess my baby 
> needs a new pair of nikes. I just had the tube replaced for now but 
> will most likely be doing this again. Thanks for the help.
>Regards
>Danny
>
>
>----- Original Message ----
>From: Robert L. Holtzer <rholtzer at earthlink.net>
>To: Farmall/IHC mailing list <farmall at lists.antique-tractor.com>
>Sent: Monday, October 2, 2006 7:50:32 PM
>Subject: Re: [Farmall] Farmall H rear tire mounting process.
>
>
>Some clarification needed.  Are you refering to removing the rim and
>tire combo?  Assuming you are talking about remounting the rim/tire,
>the rim will center assuming it was centered OK originally.  The
>outside clamps (probably not the right word!) should be installed so
>the nut seating surface is perpendicular to the bolt.  These clamps
>are used for a variety of wheel width settings so they can be
>installed tilted!   I try to mount the rim back in the position
>originally mounted to minimize paint damage.
>
>Bob Holtzer
>
>
>_______________________________________________
>Farmall mailing list
>http://www.antique-tractor.com/mailman/listinfo/farmall
>_______________________________________________
>Farmall mailing list
>http://www.antique-tractor.com/mailman/listinfo/farmall