[AT] Diesel fuel line

[Chuck Saunders]

Brass will probably be your only choice, but the cross section is much
greater and therefore the flexing that causes the work hardening will be
greatly reduced.
Chuck

On 11/27/06, rdhaskell at juno.com <rdhaskell at juno.com> wrote:
>
> Hi again.
> This brings up another question.  The real problem was in a brass elbow
> coming out of the fuel filter for the return line.  It had the crack that
> was leaking Diesel.  Will I have the same problem with the brass fitting
> as I would have from a copper line of work hardening and cracking?  If so
> where do I look for a fitting that is not brass.  It goes from 1/8" pipe
> to ferrule (SP).  Thanks.
>
> Ron Haskell
> rdhaskell at juno.com
> Riverside, California
> USA
> http://albums.photo.epson.com/j/AlbumList?u=3009370&f=0
> _______________________________________________
> AT mailing list
> Remembering Our Friend Cecil Monson 11-4-2005
> http://www.antique-tractor.com/mailman/listinfo/at
>