[AT] Cockshutt 40
Ralph Goff
alfg at sasktel.net
Sat Nov 25 22:33:44 PST 2006
Steve W. wrote:>
> Grab a dremel type tool, with a good burr or cut off wheel in it that
> nut would be cut in about 10 minutes. I have used mine many times on old
> equipment. From using a small wire wheel to clean out the tight corners
> in a mag or carb to cutting grooves for retaining rings. Many uses for
> one in a shop.
>
Steve, I have one of those and did consider it but it would mean
disassembling the mill to get it into the workshop. The dremel tool I
have is a cheap little air powered one from Princess Auto but has a
good quality burr wheel on it that might just fit inside the pulley and
cut through the nut. I may have to do this eventually.
Ralph in Sask.
More information about the AT
mailing list