[AT] Wis. carb. needed

[John Wilkens]

Yep, that's the one.  I found a good carb off of a Kohler engine but 
the Wisconsin mounting studs are at a 45 degree angle instead of the 
ususal horizontal or vertical configuration like the Kohler.  I'm 
thinking of making an adapter--but then the throttle shaft comes out 
in the wrong place.  Kevin says he might have a spare carb so I'll 
check with him first.     John


At 07:03 PM 06/22/2006, you wrote:
>Is this your propane conversion project? You might look around for one
>off a scrapped garden tractor that has about the same horsepower and
>mate that up.
>
>Just a thought.
>
>Ken in AZ
>
>On 6/22/06, John Wilkens <jwilkens at eoni.com> wrote:
>>Anybody know where I might find a used carb that would work on a
>>Wisconsin 12 HP single cylinder engine?   John W.
>>
>>                     In the wide-open spaces of NE Oregon
>>
>>
>>
>>_______________________________________________
>>AT mailing list
>>Remembering Our Friend Cecil Monson 11-4-2005
>>http://www.antique-tractor.com/mailman/listinfo/at
>_______________________________________________
>AT mailing list
>Remembering Our Friend Cecil Monson 11-4-2005
>http://www.antique-tractor.com/mailman/listinfo/at


                    In the wide-open spaces of NE Oregon