[Farmall] CUB Pulley

[szabelsk at gdls.com]

I'm in the process of putting together the engine on my Cub and need some
advise from those who know. When installing the drive pulley on the
crankshaft it calls for a special tool. I plan to use a 7/16 bolt and
appropriate washers and nut to press the pulley onto the crankshaft. My
question is this: Is there some predefined distance that the special tool
sets the pulley at? Or do I press the pulley onto the crankshaft till it
bottoms out? I realize the drive pulley has to line up with fan pulley and
figure I'll just press the pulley on until the two line up square and
flush. Any comments?

Carl Szabelski



This is an e-mail from General Dynamics Land Systems. It is for the intended recipient only and may contain confidential and privileged information.  No one else may read, print, store, copy, forward or act in reliance on it or its attachments.  If you are not the intended recipient, please return this message to the sender and delete the message and any attachments from your computer. Your cooperation is appreciated.