[AT] OT - using pitchfork

[Vaughn Miller]

The question I have is : What do you do with a handle that is loose?  I have
a manure fork that falls out of the handle.  I'd rather not replace the
handle, as it is not broken.  Any ideas?

Vaughn Miller
Dillsburg PA

>>> rugenl at yahoo.com 2/6/06 1:00:14 PM >>>
Pitchforks usually have a tang that inserts into a hole on the end of the 
handle.  The handle has a metal collar, but they aren't connected.  I think

you can drill (use a metal bit) until you hit the tang, then open a vice 
enough to let the fork pass but catch on the handle and drive the tang out.

I seem to remember they are a lot easier to change than a shovel handle. 
If 
they are old and a little loose, you may be able to just drive the old 
handle off without drilling first.  We used to lay them under the wood
stove 
and let them dry and shrink for a few days, then they nearly fell off.  It

wasn't too hot to touch, but dries enough to shrink the handle.

A pitchfork was an essential tool for the AC Roto balers.

Pitich forks have 3 tines, manure forks have more 4-6 tines, if it looks 
like a scoop shovel with tines, it's a silage fork.  If it has 3 tines and
a 
LONG handle, it's a bundle fork, for pitching wheat bundles onto a TALL 
wagon.






---
[This E-mail scanned for viruses by Declude Virus]

_______________________________________________
AT mailing list
Remembering Our Friend Cecil Monson 11-4-2005
http://www.antique-tractor.com/mailman/listinfo/at