Was [AJD] GP value Now D pto shield

[kreig]

Why not make one??   You could probably borrow one for a pattern?  I assume 
we are talking sheet metal??

Kreig

----- Original Message ----- 
From: "Gary Epps" <garyepps at fidnet.com>
To: "Antique John Deere mailing list" 
<antique-johndeere at lists.antique-tractor.com>
Sent: Monday, August 21, 2006 9:31 PM
Subject: Was [AJD] GP value Now D pto shield


> It was a long shot at best.  Does anyone else have a pto shield that would 
> fit a 1935 D?
>
> Gary
> ----- Original Message ----- 
> From: "Bill Brueck" <b2 at chooka.net>
> To: "'Antique John Deere mailing list'" 
> <antique-johndeere at lists.antique-tractor.com>
> Sent: Monday, August 21, 2006 10:14 PM
> Subject: RE: [AJD] GP value
>
>
>> Nope, got one pto between the 2 of them, and I guess it'll need a shield,
>> too, when I get that far.  For the record, these are 28 and 29 models, in
>> case anybody else is looking for something.  They aren't very accessible 
>> at
>> the moment but that can change with a few hours of jockeying around.
>>
>> My wife isn't impressed, but I think I do a pretty good job of packing in
>> tps: tractors per square foot.  I know the ATIS lists have had threads of
>> TPA - tractors per acre - from time to time.  I do especially well with 
>> the
>> narrow front end models, alternating front and back.  Sure makes it a
>> nuisance to get to one in the back, however!  Then I stick the gas 
>> engines
>> into the small spots in between.
>>
>> B²
>>
>> Bill Brueck (brick)
>> Chatfield, MN, USA
>>
>> Confusion is a higher state of knowledge than ignorance.
>>
>
>
> _______________________________________________
> Antique-johndeere mailing list
> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere