[AT] NH 376
Greg Hass
gkhass at avci.net
Fri Apr 14 19:14:17 PDT 2006
Some years ago my uncle had a NH 268 baler that kept shearing pins. After a
couple of hours of troubleshooting they found the problem; a damn piece of
metal kept getting in the way of the plunger arm. Using some good German
ingenuity they found a way to wire that metal out of the way, and away they
went. Five hours later,450 dollars poorer, a few hours work by the baler
repair man, a new set of needles, and the proper timing ; and they were
baling right along.
Greg Hass
Michigan
More information about the AT
mailing list