[AT] OT Heating with wood
charlie hill
chill8 at cox.net
Thu Sep 29 11:27:43 PDT 2005
Thanks Mike that is kinda what I had in mind. I saw the SS flex pipe on a
web site and considering what it is it really isn't all that expensive. I
think 12 feet will get me up the chimney far enough to be clear of the roof
and maybe all the way out.
Greg I am sure you are right about the cost of doing it to code and I do
want it to be safe but if it cost that much to install it I'm a LOT better
off to just keep burning fuel oil. Even if it goes to $3.00 a gal.
Charlie
----- Original Message -----
From: <msm10301 at juno.com>
To: <at at lists.antique-tractor.com>
Sent: Thursday, September 29, 2005 2:03 PM
Subject: Re: [AT] OT Heating with wood
> Charlie,
> A few years ago, I installed a Lopi insert into an existing masonary
> fireplace. I removed the damper, and made a plate out of 1/8" steel. After
> cutting a hole in the plate, I secured it to the inside of the fireplace
> with some high temp furnace cement. Then I ran an 8' section of stainless
> flex pipe up into the chimney. I had a two story house, and had no
> problems with this setup.
> Mike
>
>
> -- "charlie hill" <chill8 at cox.net> wrote:
> With the price of fuel I'm thinking of going back to good old wood heat.
> The easiest and cheapest way for me to do that is to place a wood stove
> that
> I have (modern type slow burn built of of steel plate and lined with fire
> brick) in front of and partially in my fireplace.
>
> I need opinions on the best way to connect the pipe from the heater too
> the
> damper opening in the fireplace. My thinking is to make a plate to fit in
> the place of the damper with a square to round adapter from the plate to
> the
> stove pipe. I don't want kreosote dripping into the fireplace and I sure
> don't want a chimney fire. Any ideas?
>
> If I can get this rigged up cheap enough maybe my tractor can haul some
> wood
> this winter. If it's going to cost a lot to make it work I may be better
> off paying for fuel.
>
> Charlie
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Anti-Virus.
> Version: 7.0.344 / Virus Database: 267.11.8/113 - Release Date: 9/27/2005
>
>
More information about the AT
mailing list