[Steam-engine] boiler feedwater injector conection

[Richard Strobel]

Charlie FWIW, the inspector said no welding.  Metal has to be matched, so a 
sample off the boiler would have to go to diagnostics and then the weldolet 
would have to be found with the same properties.

  Why not Tee off the steam outlet, Eric?

Rick



----- Original Message ----- 
From: <CopperheadMarine at aol.com>
To: <steam-engine at lists.stationary-engine.com>
Sent: Saturday, November 05, 2005 5:48 PM
Subject: Re: [Steam-engine] boiler feedwater injector conection


> Eric
>
>   I think you can drill and tap up to half inch. but that may depend  on
> shell thickness?
>
>  Always thought the injector steam feed should be as high as you can  get 
> it?
>
>  I wonder if weldolets are acceptable?
>
> Charlie
> _______________________________________________
> Steam-engine mailing list
> http://www.stationary-engine.com/mailman/listinfo/steam-engine
>