[Steam-engine] Ultrasound test on vertical boiler

Eric Applegate eric at glassactonline.com
Fri Nov 4 07:20:27 PST 2005


Hi Rick,
What did your boiler start out as?  Is it 1/4" plate or more?

Eric

---------- Original Message ----------------------------------
From: "Richard Strobel" <Richard_Strobel7 at msn.com>
Reply-To: Steam-engine mailing list <steam-engine at lists.stationary-engine.com>
Date:  Fri, 4 Nov 2005 07:36:52 -0700

>Sorry gang..the thinnest measurement that I saw was .213 inches.  sorry if I 
>caused any confusion.
>
>Rick
>
>
>----- Original Message ----- 
>From: "Richard Strobel" <Richard_Strobel7 at msn.com>
>To: "Steam-engine mailing list" <steam-engine at lists.stationary-engine.com>
>Sent: Friday, November 04, 2005 6:35 AM
>Subject: [Steam-engine] Ultrasound test on vertical boiler
>
>
>> Howdy all;
>>   Yesterday was a fine day with the Mt. boiler inspectors showing up in 
>> full force and we all had a great time!!! Learned a lot and still got a 
>> long ways to go with school and all.  I believe the thinnest measurement 
>> was around 213.  We're hoping for 80 psi but numbers still need to be 
>> plugged in and some questions researched.
>>
>> Pix's at:
>>
>> http://community.webshots.com/album/495773965ZtnFgK
>>
>> Hope this helps the newbee's to understand Ultra-Sound as much as it did 
>> Corky and I.
>>
>> Regards
>> RickinMt. _______________________________________________
>> Steam-engine mailing list
>> http://www.stationary-engine.com/mailman/listinfo/steam-engine
>> 
>_______________________________________________
>Steam-engine mailing list
>http://www.stationary-engine.com/mailman/listinfo/steam-engine
>

--
Thanks,
     Eric Applegate
--



More information about the AT mailing list