[AT] AC WD45 Tranny question

[two4ac at earthlink.net]

My B was stuck in first gear a few years back.  I took the plate off the 
side of the tranny and the shifter had come out of the forks.  I just put it 
back in.  Be carefull, I lost the first gear ball bearing when I did this. 
except for it not "clicking" into first it has been OK since.  I am not sure 
how the tranny is on a WD45, but this might help you get started.

David D. Gibson
1941 Allis Chalmers B
1942 Allis Chalmers C
1947 Allis Chalmers C
1948 Allis Chalmers C
1972 Allis Chalmers Homesteader
----- Original Message ----- 
From: "Al Walker" <alwalker at gvtel.com>
To: <at at lists.antique-tractor.com>
Sent: Tuesday, March 29, 2005 2:31 AM
Subject: [AT] AC WD45 Tranny question


> Hi all,
> The shifting on my WD45 has been sloppy for years. Right now, I have it in 
> 1st gear and can not shift it out. I suspect the shift lever may have come 
> out of position.  Is this likely to be in the tranny itself, or could it 
> be "just" the shift tower assembly? Is there a kit, or recommended group 
> of parts, to re-build such a shift tower?  Sorry, only have operators 
> manual, no parts or service manuals yet. Recommendations for these 
> manuals?  Thanks in advance.
> Al in sunny NW MN.
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>
>
> -- 
> No virus found in this incoming message.
> Checked by AVG Anti-Virus.
> Version: 7.0.308 / Virus Database: 266.8.4 - Release Date: 3/27/2005
>
>