[AJD] dltx carburator part

[Frank]

it might also be a 26 or 46 which would also be quite different

Frank
gremaux at tein.net
Central Montana
http://www.angelfire.com/mt/deeregp/index.html
----- Original Message ----- 
From: <greg at theoldtractorcompany.com>
To: "Antique John Deere mailing list" 
<antique-johndeere at lists.antique-tractor.com>
Sent: Saturday, July 23, 2005 10:55 PM
Subject: Re: [AJD] dltx carburator part


>
> Marc
> We usually just rework the seating area where the seat seals against and 
> if needed apply a bit
> of expoxy. Never had a problem after that
> I am sure there are more techically correct repairs but it's always worked 
> for us. I usually
> only replace a bowl if it has been cracked, I don't care for cracks.
> Also, you had best check your DLT # so you are sure to get the right bowl 
> as there are three
> (right?) different bowls. One for the brass body carbs, one for the common 
> carbs and one for
> the DLTX71 "big nut" carb.
> Greg
>
> Greg Stephen
> The Old Tractor Company
> Stephen Equipment Company
> PO Box 709
> Franktown, CO 80116
> 303-663-5246
> 303-468-0377 FAX<<--GREAT WAY TO REACH ME!
>
> On Sat Jul 23 16:22 , 'Marc Raasch' <mraasch at hickorytech.net> sent:
>
>>Looking for any body that might have a fload bowl
>>for two cylinder jd tractor.
>>Can't get the needle seat to seal down properly as it is
>>to much on one side where the gasket seals.  Thanks for any help
>>Marcus Raasch
>>St Peter MN.
>>mraasch at hickorytech.net
>>_______________________________________________
>>Antique-johndeere mailing list
>>http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
>
>
>
> _______________________________________________
> Antique-johndeere mailing list
> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
>
>