[AJD] dltx carburator part

[Marc Raasch]

bruce
The threads are ok.  It is just that some of the seating area is rusted 
away.
Thid part was quite rusty and bead blasting cleaned up one side where the 
needle seat body screws down against.
Hope every body can figure out what I am on about.
Marc
----- Original Message ----- 
From: "Bruce Mahr" <martian at winco.net>
To: "Antique John Deere mailing list" 
<antique-johndeere at lists.antique-tractor.com>
Sent: Sunday, July 24, 2005 2:57 PM
Subject: Re: [AJD] dltx carburator part


> Marc: If the seat doesn't touch on one side, someone as evidently cross 
> threaded the seat some time or another and it's not straight. Have you 
> tried a new seat and , or to straighten up the threads?
>
> Bruce Mahr
>
> ----- Original Message ----- 
> From: "Marc Raasch" <mraasch at hickorytech.net>
> To: "Antique John Deere mailing list" 
> <antique-johndeere at lists.antique-tractor.com>
> Sent: Sunday, July 24, 2005 1:41 PM
> Subject: Re: [AJD] dltx carburator part
>
>
>> The bowl is a dlt 13
>> JD #r10009
>> The reason I didn't want to use epoxy is that I plan on
>> selling this carb either on Le Suer swap meet of on EBay.
>> If i were using on a tractor of mine I guess I would doctor it up
>> with epoxy
>> Marc
>> ----- Original Message ----- 
>> From: "Frank" <gremaux at tein.net>
>> To: "Antique John Deere mailing list" 
>> <antique-johndeere at lists.antique-tractor.com>
>> Sent: Sunday, July 24, 2005 9:30 AM
>> Subject: Re: [AJD] dltx carburator part
>>
>>
>>> it might also be a 26 or 46 which would also be quite different
>>>
>>> Frank
>>> gremaux at tein.net
>>> Central Montana
>>> http://www.angelfire.com/mt/deeregp/index.html
>>> ----- Original Message ----- 
>>> From: <greg at theoldtractorcompany.com>
>>> To: "Antique John Deere mailing list" 
>>> <antique-johndeere at lists.antique-tractor.com>
>>> Sent: Saturday, July 23, 2005 10:55 PM
>>> Subject: Re: [AJD] dltx carburator part
>>>
>>>
>>>>
>>>> Marc
>>>> We usually just rework the seating area where the seat seals against 
>>>> and if needed apply a bit
>>>> of expoxy. Never had a problem after that
>>>> I am sure there are more techically correct repairs but it's always 
>>>> worked for us. I usually
>>>> only replace a bowl if it has been cracked, I don't care for cracks.
>>>> Also, you had best check your DLT # so you are sure to get the right 
>>>> bowl as there are three
>>>> (right?) different bowls. One for the brass body carbs, one for the 
>>>> common carbs and one for
>>>> the DLTX71 "big nut" carb.
>>>> Greg
>>>>
>>>> Greg Stephen
>>>> The Old Tractor Company
>>>> Stephen Equipment Company
>>>> PO Box 709
>>>> Franktown, CO 80116
>>>> 303-663-5246
>>>> 303-468-0377 FAX<<--GREAT WAY TO REACH ME!
>>>>
>>>> On Sat Jul 23 16:22 , 'Marc Raasch' <mraasch at hickorytech.net> sent:
>>>>
>>>>>Looking for any body that might have a fload bowl
>>>>>for two cylinder jd tractor.
>>>>>Can't get the needle seat to seal down properly as it is
>>>>>to much on one side where the gasket seals.  Thanks for any help
>>>>>Marcus Raasch
>>>>>St Peter MN.
>>>>>mraasch at hickorytech.net
>>>>>_______________________________________________
>>>>>Antique-johndeere mailing list
>>>>>http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
>>>>
>>>>
>>>>
>>>> _______________________________________________
>>>> Antique-johndeere mailing list
>>>> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
>>>>
>>>>
>>>
>>> _______________________________________________
>>> Antique-johndeere mailing list
>>> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
>>>
>>>
>>>
>>> -- 
>>> No virus found in this incoming message.
>>> Checked by AVG Anti-Virus.
>>> Version: 7.0.338 / Virus Database: 267.9.4/57 - Release Date: 7/22/2005
>>>
>>>
>>
>> _______________________________________________
>> Antique-johndeere mailing list
>> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
>>
>
>
> _______________________________________________
> Antique-johndeere mailing list
> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
>
>
>
> -- 
> No virus found in this incoming message.
> Checked by AVG Anti-Virus.
> Version: 7.0.338 / Virus Database: 267.9.4/57 - Release Date: 7/22/2005
>
>