[AJD] dltx carburator part

[Frank]

you are looking in the wrong bars.......

Frank
gremaux at tein.net
Central Montana
http://www.angelfire.com/mt/deeregp/index.html
----- Original Message ----- 
From: <greg at theoldtractorcompany.com>
To: "Antique John Deere mailing list" 
<antique-johndeere at lists.antique-tractor.com>
Sent: Sunday, July 24, 2005 10:18 AM
Subject: Re: [AJD] dltx carburator part


> Right.
> Or, way I think about it, little hole, regular hole, big hole.
>
> Greg
>
> Greg Stephen
> The Old Tractor Company
> Stephen Equipment Company
> PO Box 709
> Franktown, CO 80116
> 303-663-5246
> 303-468-0377 FAX<<--GREAT WAY TO REACH ME!
>
> On Sun Jul 24  8:30 , 'Frank' <gremaux at tein.net> sent:
>
>>it might also be a 26 or 46 which would also be quite different
>>
>>Frank
>>gremaux at tein.net
>>Central Montana
>>http://www.angelfire.com/mt/deeregp/index.html
>>----- Original Message ----- 
>>From: greg at theoldtractorcompany.com>
>>To: "Antique John Deere mailing list"
>>antique-johndeere at lists.antique-tractor.com>
>>Sent: Saturday, July 23, 2005 10:55 PM
>>Subject: Re: [AJD] dltx carburator part
>>
>>
>>>
>>> Marc
>>> We usually just rework the seating area where the seat seals against and
>>> if needed apply a bit
>>> of expoxy. Never had a problem after that
>>> I am sure there are more techically correct repairs but it's always 
>>> worked
>>> for us. I usually
>>> only replace a bowl if it has been cracked, I don't care for cracks.
>>> Also, you had best check your DLT # so you are sure to get the right 
>>> bowl
>>> as there are three
>>> (right?) different bowls. One for the brass body carbs, one for the 
>>> common
>>> carbs and one for
>>> the DLTX71 "big nut" carb.
>>> Greg
>>>
>>> Greg Stephen
>>> The Old Tractor Company
>>> Stephen Equipment Company
>>> PO Box 709
>>> Franktown, CO 80116
>>> 303-663-5246
>>> 303-468-0377 FAX
>>>
>>> On Sat Jul 23 16:22 , 'Marc Raasch' mraasch at hickorytech.net> sent:
>>>
>>>>Looking for any body that might have a fload bowl
>>>>for two cylinder jd tractor.
>>>>Can't get the needle seat to seal down properly as it is
>>>>to much on one side where the gasket seals.  Thanks for any help
>>>>Marcus Raasch
>>>>St Peter MN.
>>>>mraasch at hickorytech.net
>>>>_______________________________________________
>>>>Antique-johndeere mailing list
>>>>http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
>>>
>>>
>>>
>>> _______________________________________________
>>> Antique-johndeere mailing list
>>> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
>>>
>>>
>>
>>_______________________________________________
>>Antique-johndeere mailing list
>>http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
>
>
>
> _______________________________________________
> Antique-johndeere mailing list
> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
>
>