[AJD] dltx carburator part

[Marc Raasch]

Greg
I did use some epoxy but it still leaked.
After looking at it again it looked like there wasn't enough epoxy at the 
right place.
Thanks for the input.
Marc

----- Original Message ----- 
From: <greg at theoldtractorcompany.com>
To: "Antique John Deere mailing list" 
<antique-johndeere at lists.antique-tractor.com>
Sent: Saturday, July 23, 2005 11:55 PM
Subject: Re: [AJD] dltx carburator part


>
> Marc
> We usually just rework the seating area where the seat seals against and 
> if needed apply a bit
> of expoxy. Never had a problem after that
> I am sure there are more techically correct repairs but it's always worked 
> for us. I usually
> only replace a bowl if it has been cracked, I don't care for cracks.
> Also, you had best check your DLT # so you are sure to get the right bowl 
> as there are three
> (right?) different bowls. One for the brass body carbs, one for the common 
> carbs and one for
> the DLTX71 "big nut" carb.
> Greg
>
> Greg Stephen
> The Old Tractor Company
> Stephen Equipment Company
> PO Box 709
> Franktown, CO 80116
> 303-663-5246
> 303-468-0377 FAX<<--GREAT WAY TO REACH ME!
>
> On Sat Jul 23 16:22 , 'Marc Raasch' <mraasch at hickorytech.net> sent:
>
>>Looking for any body that might have a fload bowl
>>for two cylinder jd tractor.
>>Can't get the needle seat to seal down properly as it is
>>to much on one side where the gasket seals.  Thanks for any help
>>Marcus Raasch
>>St Peter MN.
>>mraasch at hickorytech.net
>>_______________________________________________
>>Antique-johndeere mailing list
>>http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
>
>
>
> _______________________________________________
> Antique-johndeere mailing list
> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
>
>
>
> -- 
> No virus found in this incoming message.
> Checked by AVG Anti-Virus.
> Version: 7.0.338 / Virus Database: 267.9.4/57 - Release Date: 7/22/2005
>
>