[AT] Replacing PTO Shaft on Ferguson TO-20

[CBear81438 at aol.com]

In a message dated 7/3/2005 8:09:54 AM Central Daylight Time,  
SZakaluk at aol.com writes:

The  I&T manual says to adjust shaft bearings with shims to  permit shaft  to 
rotate freely, yet without perceptible end play. Is this  only for  the 
extension drawbar application (which I don't have)? Thanks for  any  advice.
Steve Zakaluk
Falcon CO



Steve:
I have replaced a bunch of them, about 30 years ago.  I do not  remember 
shimming the bearings.....
 
Cecil