[AT] Forklift question

[JParks]

Being a Hyster.......(assuming the Id plate is gone) the model and serial
number is stamped along the edge of the main frame.....it is on the top edge
....where the plate would be cut to form the side frames...........Usually
about 3/8" steel plate on something this size

John Parks
Boise, ID
----- Original Message -----
From: <rdhaskell at juno.com>
To: <sel at lists.stationary-engine.com>; <at at lists.antique-tractor.com>
Sent: Sunday, July 03, 2005 3:40 PM
Subject: [AT] Forklift question


> Hi all.
> I am planning on buying a small forklift.  Here is a picture, how much do
> you think it weighs?
>
> http://albums.photo.epson.com/j/View?u=3009370&a=30280826&p=72170722&Sequ
> ence=0&res=high
> The owner doesn't know anything about it.  Thanks.
>
> Ron Haskell
> rdhaskell at juno.com
> Riverside, California
> USA
> http://albums.photo.epson.com/j/AlbumList?u=3009370&f=0
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>