[Steam-engine] Small hand hole plates

[Tod Engine]

I could cast new ones for you.  Wouldn't cost you too much either.

Rick Rowlands
Tod Engine Works
Youngstown, Ohio

----- Original Message ----- 
From: "Mark" <mark at ironacres.com>
To: "Steam-engine mailing list" <steam-engine at lists.stationary-engine.com>
Sent: Thursday, January 27, 2005 3:58 PM
Subject: [Steam-engine] Small hand hole plates


> Does anyone know a good source for small hand hole plates? My 1/2 scale 
> Peerless was built with just 1/2" plugs for clean outs. This just doesn't 
> cut it for a dry bottom boiler. I'd like to put in some small hand hole 
> plates to make sure I get that water leg good and clean. I figure the live 
> steam group has some out there but thought I'd ask here first.
>
> Mark
> _______________________________________________
> Steam-engine mailing list
> http://www.stationary-engine.com/mailman/listinfo/steam-engine
>