[AJD] AA3861R (JD1260R) Wheels, hubs and clamps

[Duane Larson]

Chris,
The clamp you need depends on the hub you have.  Since your A takes a 15
spline hub for pressed steel wheels, it would be either the A2466R cast hub
which takes the A1812R clamp, or the A3248R malleable iron hub which takes
the B1961R clamp.  The A1812R clamp comes in two flavors - 5 hole and 6
hole - but they both fit the same hub.  I think I had this sorted out so if
that is an issue let me know and I'll look further in my wheel notes.
Duane Larson

----- Original Message ----- 
From: "Chris C" <jdnutinwa at yahoo.com>
To: "ATIS LIST" <antique-johndeere at lists.antique-tractor.com>
Sent: Sunday, January 02, 2005 7:49 PM
Subject: [AJD] AA3861R (JD1260R) Wheels, hubs and clamps


>
>
>      I recently bought a pair of AA3861R pressed steel
> wheels for a 1944 A that I bought.  It already has
> these wheels on it,  but they are messed up beyond
> repair.  I have the hubs,  but there are no clamps.  I
> am pretty sure I need the B1961R clamp (actually 2 of
> them)   According to the Deere site,  that is now an
> invalid part number.   Anyone know if someone is
> making them or have a pair to sell?
>
>       My next question,  I have heard tale of a home
> built 'puller' for taking hubs off of the splined
> axles.  Anyone have the plans and want to send them to
> me?
>
>                      Chris
>
> __________________________________________________
> Do You Yahoo!?
> Tired of spam?  Yahoo! Mail has the best spam protection around
> http://mail.yahoo.com
> _______________________________________________
> Antique-johndeere mailing list
> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere