[AJD] Putting the D together

[Gary Epps]

I've got a spray can of Permatex High Tack Spray-A-Gasket(the red stuff) 
   and 18 lead washers.  I plan on cleaning the studs well and lubing 
them before putting the nuts on and torquing them.

Louis, you reminded me to retorque after the engine reaches operating 
temperature.  I want to make sure I do this right this time.  I retorque 
it while the engine is hot, right?  Do the valves have to be readjusted 
after retorquing the head bolts?

Gary

greg at theoldtractorcompany.com wrote:
> I always used the specified torque
> I use CopperKote on the gasket, put the smooth side to the block and don't forget TWO lead 
> washers on each stud on the D
> Greg
> 
> Greg Stephen
> The Old Tractor Company
> Stephen Equipment Company
> PO Box 709
> Franktown, CO 80116
> 303-663-5246
> 303-468-0377 FAX<<--GREAT WAY TO REACH ME!
> 
> On Sun Feb 13 19:04 , Gary Epps <garyepps at fidnet.com> sent:
> 
> 
>>I have been advised to torque the head bolts on the D to as much as 20 
>>ft lbs over spec.  This would take it from 208 ft lbs to as much as 
>>nearly 230 ft lbs.  What numbers do you use?  Do you torque over spec? 
>>Is 208 ft lbs enough torque?  It is a beefy engine.
>>
>>Gary
>>-- 
>>In the Ozark Mountains of South Central USA where both life and I move 
>>at a leisurely pace.
>>
>>_______________________________________________
>>Antique-johndeere mailing list
>>http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
> 
> 
> 
> 
> _______________________________________________
> Antique-johndeere mailing list
> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
> 
> 
> 

-- 
In the Ozark Mountains of South Central USA where both life and I move 
at a leisurely pace.