[AJD] H Tranny

[wjohnson]

Amem!!!
Merle
-----Original Message-----
From: <greg at theoldtractorcompany.com>
To: Antique John Deere mailing list
<antique-johndeere at lists.antique-tractor.com>
Date: Mon, 07 Feb 2005 23:51:58 -0600
Subject: Re: [AJD] H Tranny

> I have found it necessary at times to have more than one size of BFH
> available to faciliate the 
> proper persuasion of reluctant parts
> Greg
> 
> Greg Stephen
> The Old Tractor Company
> Stephen Equipment Company
> PO Box 709
> Franktown, CO 80116
> 303-663-5246
> 303-468-0377 FAX<<--GREAT WAY TO REACH ME!
> 
> On Mon Feb  7 12:06 , 'Bill Brueck' <b2 at chooka.net> sent:
> 
> >A BFH judiciously used in the general area might help that penetrating
> oil a 
> >bit...
> >
> >B²
> >Bill Brueck (brick)
> >Chatfield, MN, USA
> >
> >----- Original Message ----- 
> >From: "Karl Olmstead" olmstead at ridgenet.net>
> >To: "Antique John Deere mailing list" 
> >antique-johndeere at lists.antique-tractor.com>
> >Sent: Monday, February 07, 2005 9:34 AM
> >Subject: Re: [AJD] H Tranny
> >
> >
> >> Nope.  The weekend was spent prepping and painting my house.  At
> least one 
> >> end of it.  Sun was shining; no time for tractors.  I sprayed the
> screw 
> >> with penetrating oil; hopefully it's working.
> >>
> >> -Karl
> >>
> >>
> >>
> >> -----------------
> >>> Did you get this worked out yet, Karl?
> >>>
> >>> I have the same model.  As you've discovered, after serial 10000
> they 
> >>> added a separate casting for the left bearing for this shaft.  I
> just 
> >>> looked at my IT manual and it doesn't even acknowledge the earlier
> setup. 
> >>> I suppose the official JD shop manual might help, I don't have one
> of 
> >>> those but have found the parts manual to be very helpful to get the
> >>> restoration process close to right.
> >>>
> >>> I had mine apart in the process of restoration a couple of years
> ago, I 
> >>> remember this cap screw being hard to get loose, but I'm pretty
> sure I 
> >>> must have pulled the shaft out the left side of the casing when I
> got 
> >>> done.
> >>>
> >>> Let me know if I can stare and compare anything on my machine for
> you.
> >>>
> >>> B²
> >>> Bill Brueck (brick)
> >>> Chatfield, MN, USA
> >>
> >>
> >> _______________________________________________
> >> Antique-johndeere mailing list
> >> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
> >> 
> >
> >_______________________________________________
> >Antique-johndeere mailing list
> >http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
> 
> 
> 
> _______________________________________________
> Antique-johndeere mailing list
> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere