[AT] Special Tool for VAC Case

[H. L. Staples]

You may have to visit a junk tool store or pawn shop and get an old wrench
and do some cutting and welding. or you could extend a wrench to a length of
one foot then use a spring scale to exert 65 pounds of pull.  
 
H. L. Staples
McLoud, Oklahoma
USA
-------Original Message-------
 
From: Ken and Mona Frost
Date: 02/26/05 15:04:49
To: at at lists.antique-tractor.com
Subject: [AT] Special Tool for VAC Case
 
I'm trying to find a C-wrench or T-132 tool which is an extension of a
torque wrench to tighten the nuts on the right side of the engine for my
1952 Case VAC tractor.  These studs are very hard to access with anything
but a box end wrench.  To use a torque wrench to tighten them to 65 lbs, you
need an extension like a C wrench or a T-132  Thanks.
Ken Frost
Elberta, AL
_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at