[AJD] H Tranny

[Bill Brueck]

A BFH judiciously used in the general area might help that penetrating oil a 
bit...

B²
Bill Brueck (brick)
Chatfield, MN, USA

----- Original Message ----- 
From: "Karl Olmstead" <olmstead at ridgenet.net>
To: "Antique John Deere mailing list" 
<antique-johndeere at lists.antique-tractor.com>
Sent: Monday, February 07, 2005 9:34 AM
Subject: Re: [AJD] H Tranny


> Nope.  The weekend was spent prepping and painting my house.  At least one 
> end of it.  Sun was shining; no time for tractors.  I sprayed the screw 
> with penetrating oil; hopefully it's working.
>
> -Karl
>
>
>
> -----------------
>> Did you get this worked out yet, Karl?
>>
>> I have the same model.  As you've discovered, after serial 10000 they 
>> added a separate casting for the left bearing for this shaft.  I just 
>> looked at my IT manual and it doesn't even acknowledge the earlier setup. 
>> I suppose the official JD shop manual might help, I don't have one of 
>> those but have found the parts manual to be very helpful to get the 
>> restoration process close to right.
>>
>> I had mine apart in the process of restoration a couple of years ago, I 
>> remember this cap screw being hard to get loose, but I'm pretty sure I 
>> must have pulled the shaft out the left side of the casing when I got 
>> done.
>>
>> Let me know if I can stare and compare anything on my machine for you.
>>
>> B²
>> Bill Brueck (brick)
>> Chatfield, MN, USA
>
>
> _______________________________________________
> Antique-johndeere mailing list
> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
>