[Farmall] setting clearance valves on 706 D

[Roberto Rivero]

Ok Jim, i did the job with the tractor, and the sound of engine is like
music now, the (valves lash were awfull) i donot understand why i feel that
this old engine has a very nice sound,  so thanks again.

On 12/22/05, Jim Becker <jim.becker at verizon.net> wrote:
>
> Roberto,
> A US spec 706 should have the D-282 engine.
> Firing order: 1-5-3-6-2-4
> Valve lash (intake and exhaust): .027 inch, hot
>
> Set the engine at #1 TDC on compression and set valves:
> 1_2_3___5___7___9
> Rotate one full revolution to #6 TDC on compression and set the rest:
> ______4___6___8___10_11_12
>
> Let us know if you have any other questions.
>
> Jim Becker        jim.becker at verizon.net
>
> ----- Original Message -----
> From: "Roberto Rivero" <rj.rivero at gmail.com>
> To: "Farmall/IHC mailing list" <farmall at lists.antique-tractor.com>
> Sent: Thursday, December 22, 2005 4:02 PM
> Subject: [Farmall] setting clearance valves on 706 D
>
>
> Next week end i will be in the farm and would like to set the clearrance
> of
> valves to the 706 Diesel (the engine is not the german one  but the
> american  one) with one engine of four cilinders with firing order 1342 i
> have not problem but this one with six cilinders i donot know the firing
> order, so after having the cil Nº1 on TDC i donot know how to go on, and i
> donot know the measure of the clearance too.  i have the manual of the
> engine but is in the farm now so i will see that when i arrive there.
> Thanks in advance for your help ( the inj. pump is a Roosa master for if
> that help).
>
>         good tractoring and thanks  again
> --
> Ing. Civil Roberto Rivero
> Montevideo Uruguay South Am.
> 00598 99620035
>
> _______________________________________________
> Farmall mailing list
> http://www.antique-tractor.com/mailman/listinfo/farmall
>



--
Ing. Civil Roberto Rivero
Montevideo Uruguay South Am.
00598 99620035