[AT] No spark

[James Yost]

Jeff,

Not following this discussion but I assume the obvius
has been taken care of. You do have a good rotor, cap,
and wires?

Jim

--- Jeff Green <jd_green at swbell.net> wrote:

> Yes, the points open & close
> *****************************
> Jeff G
> *****************************
> 
> ----- Original Message ----- 
> From: "Phil Auten" <pga2 at hot1.net>
> To: "Antique tractor email discussion group"
> <at at lists.antique-tractor.com>
> Sent: Sunday, August 14, 2005 10:18 PM
> Subject: Re: [AT] No spark
> 
> 
> > Are the points actually being opened by the cam in
> the distributor? 
> > The rubbing block
> > may be worn down too far.
> > 
> > Phil
> > 
> > At 08:13 AM 8/14/05, you wrote:
> >>I'm having a fit solving a real basic problem on
> my Ford 601.  Can't 
> >>get a spark.  Not at the plugs or the points.  I
> know I'm getting 
> >>power to the distributor, from getting zapped when
> I stuck a 
> >>screwdriver in the points.  I've replaced the coil
> & 
> >>condensor.  It's a 12 volt system.
> >>
> >>Any ideas on where to look next?
> >>
> >>Jeff G.
> > 
> > 
> > _______________________________________________
> > AT mailing list
> > http://www.antique-tractor.com/mailman/listinfo/at
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
> 


Jim and Janna Yost
Utica, Ohio
USA
jnyost at yahoo.com


		
____________________________________________________
Start your day with Yahoo! - make it your home page 
http://www.yahoo.com/r/hs