[AT] WD 45?
Brad Gunnells
brad-gunnells at uiowa.edu
Thu Apr 28 07:49:01 PDT 2005
I have a Gleaner E Combine and it has the 4 cylinder 226 cid engine in
it. I figured since I did the head last year on it (the rest of the
machine is marginal, and I probably couldn't sell it for the money I
put in the head) I'd save it for use in a WD/WD45 if I ran across one.
I think the govener/carb setup is a bit different but if you have that
from your existing one it shouldn't be a problem.
Often those combine engines have lower hours than a tractor of that
age. Mine had very little cylinder wear in it. I'd replace a couple of
seals and put in a tractor without batting an eye.
Brad
On Apr 28, 2005, at 9:08 AM, charlie hill wrote:
> Yes it should. In fact I think most of the antique tractor pulling
> clubs allow that swap. Look at the combine engines. I think the D-17
> engine was used in some of the combines.
>
> Charlie
> ----- Original Message ----- From: "James Yost" <jnyost at yahoo.com>
> To: "Tractor" <at at lists.antique-tractor.com>
> Sent: Thursday, April 28, 2005 7:42 AM
> Subject: [AT] WD 45?
>
>
>> Will a D17 block fit in a WD45? I am going to a
>> auction tomorrow that was a tractor junk yard. They
>>
>> <snip>
>> Thanks, Jim
>>
>>
>>
>> Jim and Janna Yost
>> Utica, Ohio
>> USA
>> jnyost at yahoo.com
>>
>>
---------------------------------------------------------------------
Brad Gunnells | #
University of Iowa | ||
Information Technology Services | I_ ___ at ___||_____
Campus Services/ITC Technical Support | |__ I \ |Allis Chalmers|
Iowa City IA 52242 | ___\___ \ \ WC|
(319)335-5524 FAX (319)335-5505 | * * *___|__\__________ -|
mailto:brad-gunnells at uiowa.edu | * *----------------\___|
| * @ * oo
Interested in almost anything | * * o o
besides work! ;^) | * * * oo
Web Space: http://www.southslope.net/~gunnells/
---------------------------------------------------------------------
More information about the AT
mailing list