[AT] Replacing PTO Shaft, Ferguson TO-20

[CBear81438 at aol.com]

In a message dated 4/24/2005 8:17:34 AM Central Daylight Time,  
SZakaluk at aol.com writes:

Looking  for any suggestions or advice. I'm replacing the 1 1/8 PTO shaft on 
my  1951 Ferguson TO-20 with a new 1 3/8 shaft, primarily because the old 
seal  
is leaking badly. Also, do I need to drain the transmission, etc. first or  
can 
I just park in a nose down position? Thanks for any  information.

Steve  Zakaluk
szakaluk at aol.com




You can park it in a nose down position if you can get it on about a 45 deg  
angle.  I would drain the fluid and clean out the sump and screen if it has  
one at this time....   Can't stress clean oil enough in these...  
 
Cecil in OKla