[AT] WD/WD45 Intermediate Gear Removal

[charlie hill]

Hi Will,

I usually try to tackle AC questions but your's is one I can't help with. 
Maybe someone will speak up.

Charlie
----- Original Message ----- 
From: "Will Powell" <william.neff.powell at comcast.net>
To: "'Antique tractor email discussion group'" 
<at at lists.antique-tractor.com>
Sent: Tuesday, April 19, 2005 10:00 AM
Subject: [AT] WD/WD45 Intermediate Gear Removal


> Hello;
>
> I am attempting to remove the PTO intermediate drive gear from an old
> WD45 transmission housing. I then need to take the gear and place it
> into a WD.
>
> I remember reading that removal of the gear can be done without
> splitting the tractor.
>
> I have removed the hydraulic pump, the PTO gear housing and the shaft
> set screw.
>
> Now what? I have attempted to place a small amount of pressure with a
> screw driver between the Thrust washer and the Shaft, but it is not
> budging. How do I remove the Shaft?
>
> Any suggestions are welcome.
>
> I have received one suggestion from allischalmers.com.
>
> " Stick a small screwdriver where the set screw was removed and start
> prying the shaft towards the hydraulic reservoir."
>
> Will that be enough pressure to move the shaft forward, and, will the
> gear drop out if the shaft does come out?
>
>
>
>
>
>
>
> Regards;
>
> Will Powell
> Pottstown, PA
>
>
>
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>