[Steam-engine] Worm Gear

[Jim Showers]

Hopefully it will be back on the road next week.  The guy that resurfaced
the valves and seats didn't do such a good job and is now making it right.
He usually is a good machinist.  He left a small ridge on one of the valves
and that was where the squealling was coming from.  Occasionally I get
disgusted with the car, but then remember that it hasn't run since WWII and
will be great once all the bugs are worked out.
Jim


----- Original Message ----- 
From: "Beth" <24port at accesstoledo.com>
To: "Steam-engine mailing list" <steam-engine at lists.stationary-engine.com>
Sent: Tuesday, September 14, 2004 8:48 PM
Subject: Re: [Steam-engine] Worm Gear


> Hi Jim,
>
> Were you able to get the Stanley running again?
>
> Beth
> ----- Original Message ----- 
> From: "Jim Showers" <steamcar at hereintown.net>
> To: "Steam-engine mailing list" <steam-engine at lists.stationary-engine.com>
> Sent: Tuesday, September 14, 2004 5:07 PM
> Subject: Re: [Steam-engine] Worm Gear
>
>
> > If you can borrow one for a plattern, Cattail foundry will cast one from
> the
> > original.  I did that for a new set for my Peeerless.
> > Jim Showers
> >
> >
> > ----- Original Message ----- 
> > From: "Dan Donaldson" <ddonaldson at tampatank.com>
> > To: "Steam-engine mailing list"
<steam-engine at lists.stationary-engine.com>
> > Sent: Tuesday, September 14, 2004 9:18 AM
> > Subject: [Steam-engine] Worm Gear
> >
> >
> > Does anyone know where I might be able to find a worm gear for the
> steering
> > on a 22 hp Gaar Scott?
> >
> > Dan Donaldson
> > _______________________________________________
> > Steam-engine mailing list
> > http://www.stationary-engine.com/mailman/listinfo/steam-engine
> >
> >
> >
> > _______________________________________________
> > Steam-engine mailing list
> > http://www.stationary-engine.com/mailman/listinfo/steam-engine
>
>
> _______________________________________________
> Steam-engine mailing list
> http://www.stationary-engine.com/mailman/listinfo/steam-engine
>