[Steam-engine] Wachs Engine

Myron Busch oldiron at charter.net
Tue Sep 21 10:46:31 PDT 2004


Rich,
The way I do an inspection is to use a camera on macro setting. Stick your hand in the hand hole's and snap away. You will also have
an archive of the way it looks and Later after clean up you can compare shots.

Myron Busch
Northfield MN.

----- Original Message ----- 
From: "Richard Strobel" <Richard_Strobel7 at msn.com>
To: "Steam-engine mailing list" <steam-engine at lists.stationary-engine.com>
Cc: "Corky and Judy Harris" <cork_jud at msn.com>
Sent: Tuesday, September 21, 2004 7:58 AM
Subject: Re: [Steam-engine] Wachs Engine


>   Howdy Francis;
> Looking down into the boiler I saw many nice looking flue tubes.  I'd say
> ~2" in diameter.
>   On the outside were the two holes where I believe the try cocks and sight
> glass were.  There were also 3 more holes ~1/2" npt on the outside.  3 or 4
> hand holes also.
>   I'd say the flue tubes started ~ 2' up from the bottom.  BTW., our first
> lesson.  This boiler is a little top heavy.  Didn't tip it over but it got
> our attention once.
>
>    Any ideas out there on the best way to transport the boiler?  I believe
> its around 84" high...any maybe 3' in diameter.  We're thinking about
> tipping it over onto some pallets and then rolling it onto the trailer using
> maybe 4x6's to avoid the bump of the hand holes.
>
>     And does someone have a good book they'd recommend for newbee steamers?
>
> Again thanks much!!
>
> RickinMt.
>
>
>
>
> ----- Original Message ----- 
> From: "Francis Orr" <steam.boat at verizon.net>
> To: "Steam-engine mailing list" <steam-engine at lists.stationary-engine.com>
> Sent: Monday, September 20, 2004 3:37 PM
> Subject: Re: [Steam-engine] Wachs Engine
>
>
> > Lots of comments on Ricks new aquisition. No one seems to think that the
> > boiler might be a submerged tube? Not a whole lot of those around. The
> > last
> > one I saw was at the blacksmith's shop at Rollag. Rick, what did you see
> > when you were looking down into the top of the boiler?
> > Francis A. Orr
> >
> > ----- Original Message ----- 
> > From: "Richard Strobel" <Richard_Strobel7 at msn.com>
> > To: "steam-engine" <steam-engine at lists.stationary-engine.com>
> > Sent: Sunday, September 19, 2004 7:11 AM
> > Subject: [Steam-engine] Wachs Engine
> >
> >
> > >   Howdy all from Montana.
> > > My friend and I just pickedup this boiler and engine.  I usually
> > > frequent
> > > the SEL but enjoy all the steam posts also.
> > >   Any info on this engine and unmarked boiler would greatly be
> > > appreciated....ie wt., hp., rpm., etc.
> > >
> > >   Here's a picture album link to where we are getting it ready to
> > > trailer.
> > >
> > >
> > > http://community.webshots.com/album/188300547wpVzDE
> > >
> > >
> > >
> > > Thanks in anticipation!!
> > >
> > > Rick Strobel
> > > http://community.webshots.com/user/stroberc
> > > _______________________________________________
> > > Steam-engine mailing list
> > > http://www.stationary-engine.com/mailman/listinfo/steam-engine
> > >
> >
> >
> > _______________________________________________
> > Steam-engine mailing list
> > http://www.stationary-engine.com/mailman/listinfo/steam-engine
> >
> _______________________________________________
> Steam-engine mailing list
> http://www.stationary-engine.com/mailman/listinfo/steam-engine
>





More information about the AT mailing list