[AT] Old gas residue

[Steve W.]

Tom,
 Pick up a gallon or so of Lacquer thinner. Pour some in the tank and
some in a container large enough to hold the carb.
Let it set a day or so. It will dissolve the crud.

Steve


----- Original Message ----- 
From: "Tom Armstrong" <toma at risingnet.net>
To: "Antique tractor email discussion group"
<at at lists.antique-tractor.com>
Sent: Sunday, September 12, 2004 12:31 PM
Subject: [AT] Old gas residue


> I was given a Lincoln 200 welder with a V4 Wisconsin engine on it. It
has
> been sitting for many years bit the engine has compression and spark.
I
> put some gas in the tank but soon found it was not going anywhere. It
> would not even get to the filter bowl. It turned into a sticky nasty
foul
> smelling stuff. I almost wish I had not put any new gas in it, the dry
> residue might have been easier to deal with. My wife almost kicked me
out
> of the house the smell was so bad.
>
> This is something I have run into before. I suspect the gas that was
in
> there was from the '70's and all evaporated in the hot weather. I
don't
> think today's gas does this so bad.
>
> For now I am going to give up on the tank and lines and find another
tank
> and run gas direct to the carb. I think I will remove the carb and see
> what it looks like inside and clean it before I even try to run it. I
> removed a plug on the intake manifold and squirted some gas in there
and
> got the engine to pop so I think it is a runner.
>
> Tom Armstrong  toma at sangregorio.org  San Gregorio, CA  s. 1892
> Barnyard Technology--- Ideas for tomorrow -> from yesterday's scrap.
>      4th, 5th, 6th generation on family farm. Can Ag Sustain?
>                 http://www.sangregorio.org/
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>