[AT] Finally done

[charlie hill]

After looking at your picture closely I think you are missing some parts.  I 
think I can see the spring loaded rod that runs from the hydraulic pump to 
the coupler.  It is on the right side looking from the rear.  If that is 
what I am seeing you should have had a sanp coupler and the traction booster 
system.  Is there a presure guage of some sort on your instrument panel?

Charlie
----- Original Message ----- 
From: "Matthew" <matthewx at dogod.com>
To: <at at lists.antique-tractor.com>
Sent: Thursday, October 28, 2004 10:10 AM
Subject: Re: [AT] Finally done


> Re: snap coupler
>
> I have an AC and it seems to be a bit different, or it might have been
> modified before I got it.
>
> The main pulling part is way under the tractor, and you have to back the
> implament over it, being careful to be perfectly centered up.  Then you
> need to get down there and lift the thing up and get it into the hole and
> put a pin through to hold it.  The two bottom plow I have is quite heavy
> and it takes two people and a big stick as a lever to push the tongue up
> or if I am by myself I will use my hydraulic car jack to lift it up.
> Then there are two arms on the top that go to the arms that come off of
> the lift pistons.  Again, you need to futz with moving the arms and the
> implament to get it all lined up and pinned.  I have never found anything
> to effect the height of the implament except the main lift/lower lever.
>
> You can see pictures at http://badpoodle.org/tractors and you can get a
> pretty good look at the main part of the hitch in this picture:
>
> http://badpoodle.org/tractors/big/DSCN3631.JPG
>
> Am I missing pieces or was the hitch way different between the CA and the
> WD?
>
> --Matthew
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>