[AT] Gaskets for Zenith carburetors

[crawler]

John I don't have them listed in site but if you give me carb number i have
then for Zenith. The marvel's range from $1.50 -$2.50 and there are other
gaskets in the kit . Zenith's about the same. Just email me  ED



----- Original Message ----- 
From: "John Boehm" <rustyacres at yahoo.com>
To: "Antique tractor email discussion group" <at at lists.antique-tractor.com>
Sent: Tuesday, November 16, 2004 9:55 PM
Subject: Re: [AT] Gaskets for Zenith carburetors


> I know how to make gaskets, I buy the material by the
> yard when I do a tractor restoration to make gaskets
> that I know are not available. The Zenith gaskets are
> a bit harder to make than a normal gasket. I feel if I
> can find a source for them at a reasonable price, it
> is worth it to me to be able to buy them and spend my
> time doing something more productive.
>
> I do like Smitty's scanner suggestion and thank
> everyone for all the sources they suggested. I checked
> them out and did not find one with single gaskets for
> sale.
>
> John Boehm
> Woodland, CA
> Visit my web site at http://vintagetractors.com
>
>
> --- Phil Auten <pga2 at hot1.net> wrote:
>
> > John,
> > If you go to your favorite parts place you should be
> > able to buy
> > a sheet of the correct gasket material fairly
> > inexpensively. You
> > then need a utility knife, X-acto knife, single
> > edged razor blade
> > or real sharp pocket knife. Set the bowl down on the
> > material
> > and cut carefully around it. Then cut out the center
> > as required.
> > One sheet should make enough gaskets to last even
> > you for
> > some time.
> >
> > Phil
> >
> > At 09:20 PM 11/15/04, you wrote:
> > >Does anyone know of a source for the fuel bowl
> > gaskets
> > >for Zenith carburetors? On a carbuetor cleanup,
> > this
> > >is often the only part needed and I'm tired of
> > buying
> > >the whole carburetor kit for $20-$30. I have been
> > able
> > >to buy single fuel bowl gaskets for Marvel-Schebler
> > >carburetors from my John Deere dealer for around $3
> > >each. I checked today with the local AGCO dealer if
> > >the gasket listed for Allis-Chalmers B is available
> > >and they were neither helpful nor encouraging.
> > >
> > >John Boehm
> >
> >
> > _______________________________________________
> > AT mailing list
> > http://www.antique-tractor.com/mailman/listinfo/at
> >
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>
>