[AJD] Reproduction Rims, what do you think of this one?

[Terry L. Hrdlicka]

Chris,

Another reason they aren't selling is because even if they aren't 
"correct", guys like me that are working these old machines and not 
"collectors" or "restorers" can't afford them! :)

Terry



Chris C wrote:
> I knew there must be a reason that they aren't
> selling.   I was wondering about the weight holes,  I
> have not seen front weights on an A or B out here.
> 
>         Chris
> --- OLDJD4U at aol.com wrote:
> 
> 
>>Howdy guys,
>>
>>I'm sure Duane Larson can assist me with this
>>question but I felt it 
>>important to jump in on this one.  While the rim you
>>found on Ebay, will fit your "A", 
>>it's not correct.  The wheel pictured on eBay is
>>perfect for a 420 or 430 but 
>>not your "A".  Notice the (4) four square holes in
>>this rim, your original 
>>rim does not have these holes.  These holes are for
>>the mounting of the front 
>>wheel weights that the 420's and 430's use.  
>>
>>So, in essence, it will fit it, but it's not
>>correct.
>>
>>
>>Melanie Sharp
>>Sharp's Antique Tractor Works, Inc.
>>Sharp's Antique Tractor Works, Inc.
>>_______________________________________________
>>Antique-johndeere mailing list
>>
> 
> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
> 
> 
> 
> 
> 		
> __________________________________ 
> Do you Yahoo!? 
> Check out the new Yahoo! Front Page. 
> www.yahoo.com 
>  
> 
> _______________________________________________
> Antique-johndeere mailing list
> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
>