[AJD] 1931 Unstyled John Deere D Exaust Pipe and Seat

[greg at theoldtractorcompany.com]

Don
I will give you $700 for your D, you keep the pistons
(!!!)
Greg
(I know, fairly surprising but then again they are great BIG chunks of metal
Greg

Greg Stephen
The Old Tractor Company
Stephen Equipment Company
Box 709
7460 E Hiway 86
Franktown, CO 80116
303-663-5246
303-468-0377 FAX<<--A GREAT WAY TO REACH ME!


------------------------------------------------
On Sun, 7 Nov 2004 06:12:34 -0800, "bwhdon" <acton at onramp.bz> wrote:

> Good glory, 850 for pistons, I paid $700 for my running 44 d.
> 
> Don
> 
> ----- Original Message -----
> From: "Louis" <louis at kellnet.com>
> To: "'Antique John Deere mailing list'"
> <antique-johndeere at lists.antique-tractor.com>
> Sent: Saturday, November 06, 2004 8:10 PM
> Subject: RE: [AJD] 1931 Unstyled John Deere D Exaust Pipe and Seat
> 
> 
> > Kevin,
> >
> > I can get D pistons from my supplier.  They are $850 for a pair, with
> > rings and piston pins.  They are available in std., .045", .090", .125",
> > & .250" oversize.
> >
> > Thank You,
> >
> > Louis Spiegelberg
> >
> > Spiegelberg Restoration and Service, LTD.
> > 440-965-7679
> >
> > mailto:sales at srstractor.com
> >
> > http://www.srstractor.com
> >
> >
> >
> >
> > -----Original Message-----
> > From: antique-johndeere-bounces at lists.antique-tractor.com
> > [mailto:antique-johndeere-bounces at lists.antique-tractor.com] On Behalf
> > Of Kropelin
> > Sent: Saturday, November 06, 2004 9:52 PM
> > To: antique-johndeere at lists.antique-tractor.com
> > Subject: [AJD] 1931 Unstyled John Deere D Exaust Pipe and Seat
> >
> >
> > Greg,
> > Thanks for the info about the exaust pipe. All I have left is the elbow
> > . and am going to order a welded pipe from my steel supply house to
> > replace the missing section. Please let me know if by chance you run
> > across a seat spring as well as the bracket that holds it to the gear
> > housing. My next project for this "D" is to get the pistons unstuck, All
> > I am going to do is remove the block and press out the pistons in my
> > press I hope that the bore will clean up! But if it does not would you
> > or anyone happen to know if oversize pistons are avail? And what might
> > the cost for such a purchase may be?
> > Thanks Kevin
> > _______________________________________________
> > Antique-johndeere mailing list
> > http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
> >
> >
> >
> > _______________________________________________
> > Antique-johndeere mailing list
> > http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
> >
> 
> 
> _______________________________________________
> Antique-johndeere mailing list
> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
>